Home Page About Us Products Serices Support Contact us
Measuring > Linear Encoders > LIMIX (Lift Encoders)
The incremental low cost LIMIX measuring system was conceived particularly for applications within the elevator range.
 
Functions
very easy to install
direct measurement at the cabinet
insensitive (protection class IP67)
touchless & low noise scanning
0,25 / 0,5 / 1 mm resolution (depends on multi edge counter)
repeat accuracy of +/- 1 Increment
power supply / output levels as 5 V or 10-30 V
inverted signal channels
periodic index pulse (every 2 mm's)
theoretically unlimited measuring length
speed proportional real time signals
Features
The guided system, with a guidance body from slidable plastic, is simple to install, moves the scanning sensor optimally over the magnetic tape and provides with its closed lower surface permanently for the correct mounting distance between sensor and mag.
 
Technical Specifications
Resolution / Edge counter: 0.25 mm / 4 or 0.5 mm / 2 or 1 mm / 1
Repeat accuracy: +/- 1 increment
Power supply: 10... 30 VDC or 5 VDC
Signal levels: 10... 30 V-HTL or 5 V-TTL (line driver)
Consumption: max. 20 mA per channel
Outputs: push / pull, durable short-circuit-proof
Sensor housing: Zinc die cast
Protection class: IP67
Sensor dimensions: l x w x h = 30 x 12.5 x 25 mm
Working temperature: 0 °... + 65 °C
max. operating speed: 5 m/s (with HTL at optimal evaluation)
Necessary magnetic tape: MB20-20-10-1-R-D
Pole length of the magnetic tape: 2 mm
Dimensions of the slide body: l x w x h = 51 x 22 x 32 mm's (mounted state)
 
Mactrol.org @ 2010   B- 16/2, Meerut Road, Indl. Area,
Ghaziabad- 201 103