Home Page About Us Products Serices Support Contact us
Positioning > P7712/T7720 (2 x 2 axes)
Modular Axes Controller with ext. operator terminal (option).
Automatic positioning Single/Programm (with Module C)
Up to 100 program lines depositable (with Module C)
Customized front panel possible
2 Axes display with an additional speed and correction value display
16 digital inputs
8 relay outputs, 8 digital outputs
PID analog output 0...+ 10V
Serial Interfaces: 1x CAN, 2x RS232
Positioning usable features like correction, spindle compensation
Programmable end limits
Puls scaling factor
Tolerance window
Reference run etc.
Modular indicating and positioning system in open print building method for an individual installation into most diverse machine types. Custom-made software packages, e.g. for table milling- or saw machines are possible. With two of the basis dual axes modules P7712 (module A and B), up to 4 axes can be positioned by manual inching operation. These can be connected directly to the ELGO drive control card P100.05.1. The optional operator terminal module T7720 (module C) serve for comfortable operation and parameter settings of the system. Further it allows an automatic positioning of individual axes or up to 100 program lines. For communication with superordinate systems two RS232 interfaces as well as an CAN interface are available. The system is certified by the German wood employer’s liability insurance association.
Technical Specifications
Nominal voltage: 24 VDC (+/-10 %)
Power consumption: max. 300 mA
Encoder supply: 24 VDC or 5 VDC (Option)
Input signals: PNP (active high) / min. pulse time 300 ms
Input current / pin max. 10 mA
Output signals: Potential free shutter relays max. 30 DVC / 2 A
Power down memory: E² PROM app. 10 years
Connectors: plugable screw terminals
power part via RJ connector
Displays: Red LED, each 6 decades, 14 mm's high as well as diverse status LEDs
Hardware: 16Bit Microcontroller with 256 KByte PROM and 2 KByte RAM
Input frequency: 20 KHz (higher on request)
Keypad Push button switches
PCB outer dimensions ofall module (W x H) 160 x 80 mm
Install depth of all modules 90 mm (incl. connectors)
56 mm (without connectors)
Protection class IP00 (open PCB building method)
Operating temperature: 0 °... + 50 °C
Mactrol.org @ 2010   B- 16/2, Meerut Road, Indl. Area,
Ghaziabad- 201 103